「抚顺工业门封」海绵式门封的技术参数及使用注意事项 - 沈阳龙盛物流设备陕西福彩网
沈阳龙盛物流设备陕西福彩网(苏州福盛泰物流设备陕西福彩网东北办事处)
您现在的位置:陕西福彩网>>门封,卸货平台新闻 >> 「抚顺工业门封」海绵式门封的技术参数及使用注意事项

    「抚顺工业门封」海绵式门封的技术参数及使用注意事项

    作者:抚顺工业门封   发布时间: 2019/8/19 9:03:45

  •  

    「抚顺工业门封」海绵式门封的技术参数及使用注意事项


    Technical parameters and matters needing attention in the use of "Fushun Industrial Door Seal" sponge type door seals



    选择挤压式海绵门封的注意事项:封垫对墙壁产生的压力约为每米120千克。


    Notes for choosing extruded sponge door seals: The pressure generated by the seals on the walls is about 120 kg per meter.


    斜角封垫约为一半。建筑物墙壁到防撞胶平面至少要有10厘米的空隙,以为门封挤压后的厚度留有余地。


    The bevel gasket is about half. The wall of the building should have at least 10 centimeters of clearance from the collision-proof glue plane, leaving room for the thickness of the door seal after extrusion.

     

    抚顺工业门封定做




    封垫的厚度应高出防撞胶平面10到20厘米,高出15厘米适合。装卸区地面坡度大于2%时,应使用锥壮封垫。


    The thickness of the gasket should be 10 to 20 centimeters higher than the collision-proof glue plane and 15 centimeters higher. When the slope of the loading and unloading area is more than 2%, the conical sealing pad should be used.


    坡度每增加一个百分点,封垫顶部厚度比底部厚度应小2.5厘米。


    For every percentage point increase in slope, the top thickness of the gasket should be 2.5 cm less than the bottom thickness.


    海绵门封与机械门罩相比,挤压式门封能封闭货车与平台间的空隙,且成本较低,但另一方面,门封会令货台门洞的宽度减少,有时会影响托板流畅地进出货车。


    Comparing with mechanical door cover, extrusion door seal can close the gap between truck and platform at a lower cost, but on the other hand, door seal can reduce the width of the door hole of the platform and sometimes affect the smooth access of pallets to and from the truck.


    比如在另一个情况下,货车尾部有伸出的台板时,门封的使用会受到影响。平台门宽于2.8米或高于3.0米时,不能使用门封。


    For example, in another case, the use of door seals will be affected when there is an extended platform at the rear of the truck. When the platform door is wider than 2.8 meters or higher than 3.0 meters, the door seal should not be used.


    (1) 海绵垫式门封:这种门封是靠车厢的挤压达到封闭成效。它的封闭性较好,便要求厢式车型号统一。


    (1) Sponge cushion door seal: This kind of door seal is achieved by the extrusion of the carriage. Because of its good closure, the van type is required to be uniform.


    (2) 机械式门封:这种门封是靠弹性高门封帘对车厢的挤压达到封闭成效,适合大型车辆使用。


    (2) Mechanical door seals: This kind of door seals is achieved by the extrusion of the carriage by the elastic high door curtain, which is suitable for the use of large vehicles.


    (3) 充气式门封:这种门封是将货口周围的气囊充气包住车厢,达到封闭效果。它的封闭成效好, 常用在食品、等洁净度高的装卸口,适合大中型车使用。


    (3) Inflatable door seal: This kind of door seal encloses the carriage by inflating the air bag around the cargo port to achieve the sealing effect. It has good sealing effect and is often used in food and other high cleanliness loading and unloading ports. It is suitable for large and medium-sized vehicles.


    门封可有效降低装卸货时的能量损失,阻隔风雨天气、昆虫、粉尘污染等与仓库车辆内的货物接触。


    The door seal can effectively reduce the energy loss during loading and unloading, and prevent the weather, insects and dust pollution from contacting the goods in the warehouse vehicles.


    海绵门封这种装卸系统多被采用密封门,从目前来看,形成封闭式装卸系统是保护环境和货物的方法可调节高度的海绵门封让您有好的工作状态,下面「抚顺工业门封」龙盛门业为大家详解可调节高度的海绵门封让您有好的工作状态,下面我们就做出具体的分析。


    Sponge door seal, a kind of loading and unloading system, is mostly used as a sealed door. At present, forming a closed loading and unloading system is a way to protect the environment and goods. It can adjust the height of the sponge door seal so that you have a good working condition. The following "Fushun Industrial Door Seal" Longsheng Door Industry explains in detail the adjustable height of the sponge door seal for you to have a good job. For status, we will make a specific analysis below.

     

    抚顺海绵式门封安装




    「抚顺工业门封」海绵式门封的技术参数及使用注意事项



    Technical parameters and matters needing attention in the use of "Fushun Industrial Door Seal" sponge type door seals



    1、可调节海绵门封宽9’11”(3023mm),离地高 15’(4572mm),进深8”(203mm)。(基于48”(1220mm)的月台高度);


    1. Adjustable sponge door seal width 9'11 (3023 mm), height 15'(4572 mm), depth 8 (203 mm). (platform height based on 48 (1220 mm);


    2、货车的高度范围从12’3”(3734mm)到14’6”(4420mm);


    2. The height range of the truck ranges from 12'3 (3734 mm) to 14'6 (4420 mm).


    3、两侧削面型立柱在货车与建筑物墙体间形成良好密封;


    3. The two sides of the chamfered column form a good seal between the truck and the wall of the building.


    4、两侧立柱底部有透气孔,两侧立柱安装在经防腐处理的松木板上;


    4. There are ventilation holes at the bottom of both sides of the column, and the two sides of the column are installed on the anticorrosion treated pine board.


    5、内部的高密度聚氨酯海绵牢固粘合在木板上,织物包裹木板,顶篷用高密度聚氨酯海绵填充;


    5. The high density polyurethane sponge inside is firmly bonded to the board, the fabric wraps the board, and the ceiling is filled with high density polyurethane sponge.


    6、门封配有36”(914mm)高的可调节顶部门帘,两侧立柱配备高24”(610mm),宽3.5”(90mm)的倒车指引条,顶篷的高密度聚氨酯海绵牢固粘合在木板上,外表面由织物覆盖,分离式顶部门帘由尼龙搭扣连接,顶部 门帘的两端都安有层叠式耐磨褶皱


    6. The door seal is equipped with 36 (914mm) high adjustable top curtain. The two sides of the column are equipped with 24 (610mm) high and 3.5 (90mm) wide reversing guide strips. The high density polyurethane sponge of the ceiling is firmly bonded to the wooden board. The outer surface is covered by fabric. The separated top curtain is connected by nylon buckles. The two ends of the top curtain are provided with layers. Folded wear-resistant fold


    7、两侧立柱及顶部门帘织物选用22 oz黑色聚乙烯材质,顶部门帘上的耐磨褶皱选用22 oz黑色聚乙烯材质织物.


    7. The material of 22 oz black polyethylene is selected for the fabrics of the two sides pillars and the top curtain, and 22 oz black polyethylene is selected for the wear-resistant folds of the top curtain.
     

沈阳龙盛物流设备陕西福彩网
(苏州福盛泰物流设备陕西福彩网
东北办事处)
电话:024-31081023
联系人:于经理
网址:www.jiniee.com
版权所有:沈阳龙盛物流设备陕西福彩网
(苏州福盛泰物流设备陕西福彩网东北办事处)
  
电话:024-31081023
联系人:于经理
百度地图 - 网站地图 - 山西福彩网 中国竞彩网 天津福彩网 无锡体彩网 天津福彩网 无锡体彩网 山西福彩网 中国竞彩网 天津福彩网 北京福彩网